Decofrol pe baza de ulei vegetal utilizat ca tratament anti-adeziv pentru cofraje din fier, aluminiu si plastic MAPEI MAPEFORM ECO OIL

Limba: Engleza

80 afisari

Tip documentatie: Fisa tehnica

Pagina 1 - Decofrol pe baza de ulei vegetal utilizat ca tratament anti-adeziv pentru cofraje din...

m r l i o f O e o p c a M E Form release-agent based on vegetable oils WHERE TO USE Anti-adhesive treatment of iron, aluminum and plastic forms (epoxy, phenolic, polyester and polyurethane resins). • Preferably use other products from Mapeform range on raw wood forms. • Whenever using with rubber forms make sample tests or contact the MAPEI Technical Services Department. Some application examples • To facilitate form release of precast concrete. • To facilitate form release of steam-cured concrete. • To form release concrete cast in plastic forms. • To form release concrete cast in metal forms. DIRECTIONS FOR USE Mapeform Eco Oil is ready-to-use. TECHNICAL CHARACTERISTICS Mapeform Eco Oil is based on stable vegetable oils, minor parts of inhibitors, and special admixtures. Once applied Mapeform Eco Oil creates a thin layer that facilitates concrete demolding from the formwork. Mapeform Eco Oil features the following advantages: • improved surface quality thanks t

Pagina 1-Decofrol pe baza de ulei vegetal utilizat ca tratament anti-adeziv pentru cofraje din fier, aluminiu...

Pagina 2 - Decofrol pe baza de ulei vegetal utilizat ca tratament anti-adeziv pentru cofraje din...

o the drastic reduction of large and micro surface air bubbles; • less cleaning of forms; • simple low-cost application; • easily and rapidly biodegradable; non toxic, does not irritate and does not cause sensitization; • not subject to the Italian law 303 of 1956 for the use of form release-agents based on mineral oils. RECOMMENDATIONS • Do not dilute Mapeform Eco Oil with water. • Do not dilute Mapeform Eco Oil with solvents or other oils. • Do not use Mapeform Eco Oil with concrete, gypsum or polystyrene forms. Application Apply Mapeform Eco Oil on the clean, dry formwork, preferably in a single coat, using pressure pumps fitted with a misting nozzle or atomisers at a pressure of 6 Bar. For effective stripping of forms, do not exceed the recommended dosage. This can cause the formation of a fine dust on the surface which can alter the final finish. Cleaning Tools used for applying Mapeform Eco Oil can be cleaned with water. CONSUMPTION Metal forms: 15-25 g/m². Pl